Assessment of Particulate Matter Dispersion Using Gaussian Plume Model: A Case Study of Doroud Cement Factory

Authors

  • Yusef Omidi-Khaniabadi1 1- Health System of Karoon, Ahvaz Jundishapur University of Medical Sciences, Ahvaz, Iran.
  • Shirin Emaeili2 2- Dept. of Environmental Health, School of Public Health, Ahvaz Jundishapur University of Medical Sciences, Ahvaz, Iran.
  • Gholamreza Goudarzi3 3- Environmental Technologies Research Center, Ahvaz Jundishapur University of Medical Sciences, Ahvaz, Iran.
  • Rajab Rashidi4 4- Dept. of Occupational Health, School of Health, Lorestan University of Medical Sciences, Khorramabad, Iran.
  • Mohammad Khoshgoftar5 5- Vice-chancellery of Health, Shahroud University of Medical Sciences, Shahroud, Iran.

DOI:

https://doi.org/10.22100/jkh.v12i4.1748

Keywords:

Dust dispersion, Gaussian plume, Cement plant

Abstract

Introduction: The dispersion of particulate matter has been known as the most serious environmental pollutant from the cement plants. In this study, the dispersion of dust (PM10) from the stack of Doroud Cement plant was investigated using Gaussian plume model in different atmospheric conditions.

Methods: In this study, westech instrument was used to measure PM10 level by gravimetric method based on ISO-9096 standard. The Gaussian plume model was used for predict PM10 concentrations in certain intervals. The results were compared with 24 hour EPA standard for PM10. The effect of meteorological parameters including temperature, wind speed and relative humidity on the PM10 dispersion were assessed.

Results: The results showed that the maximum and minimum predicted concentrations in ambient air were obtained at the distance of 1800 and 500 meter from the source with concentrations of 118.12 and 53.13 µg/m³, respectively. The increment of wind speed and increasing of air stability had an important role in rising of dust in atmosphere surrounding of cement plant.

Conclusion: The comparison of results with EPA standard showed that PM10 concentrations were not higher than standard during sampling period. The further field investigations to measure PM10 in upwind and downwind of cement plant and compare with the results of modeling are essential.

References

Daryanoosh M, Goudarzi GH, Rashidi R, Keishams F, Hopke PK, Mohammadi MJ, et al. Risk of morbidity attributed to ambient PM10 in the western cities of Iran. Toxin Reviews 2017;1-6. doi: 10.1080/15569543.2017.1370602

Khaniabadi YO, Hopke PK, Goudarzi G, Daryanoosh SM, Jourvand M, Basiri H. Cardiopulmonary mortality and COPD attributed to ambient ozone. Environ Res 2017;152:336-41. doi: 10.1016/j.envres.2016.10.008

Khaniabadi YO, Goudarzi G, Daryanoosh SM, Borgini A, Tittarelli A, De Marco A. Exposure to PM10, NO2, and O3 and impacts on human health. Environ Sci Pollut Res 2017;24:2781-9.

Farhadi M, Sicard P, De Marco A, Khoshgoftar M, Taiwo AM, Mohammadi MJ, et al. Hot spots of NOx emission from the cement factory main stacks. Fresenius Environ Bull 2017;26: 8345-552.

Seangkiatiyuth K, Surapipith V, Tantrakarnapa K, Lothongkum AW. Application of the AERMOD modeling system for environmental impact assessment of NO2 emissions from a cement complex. J Environ Sci 2011;23:931-40.

Abu-Allaban M, Abu-Qudais H. Impact assessment of ambient air quality by cement industry: a case study in Jordan. Aerosol Air Qual Res 2011;11:802-10. doi: 10.4209/aaqr.2011.07.0090

Shahsavani A, Naddafi K, Jafarzade Haghighifard N, Mesdaghinia A, Yunesian M, Nabizadeh R, et al. The evaluation of PM10, PM2.5, and PM1 concentrations during the Middle Eastern Dust (MED) events in Ahvaz, Iran, from april through september 2010. J Arid Environ 2012;77:72-83.

Shakour A, El-Shahat M, El-Taieb N, Hassanein M, Mohamed A. Health impacts of particulate matter in greater Cairo, Egypt. J Am Sci 2011;7:840-8.

Marcona A, Pesce G, Girardi P, Marchetti P, Blengio G, Sappadin SdZ, et al. Association between PM10concentrations and school absences inproximity of a cement plant in northern Italy. Int J Hyg Environ Health 2014;217:386- 91. doi: 10.1016/j.ijheh.2013.07.016

Yatkin S, Bayram A. TSP, PM depositions, and trace elements in the vicinity of a cement Plant and their source apportionments using chemical mass balance model in Izmir, Turkey. Environ Monit Assess 2010;167:125-41. doi: 10.1007/s10661-009-1036-0

El-Kilani R, Belal MH. Modelling an environmental pollutant transport from the stacks to and through the soil. J Adv Res 2010;1:243-53. doi: 10.1016/j.jare.2010.05.009

Mohebbi A, Baroutian S. A detailed investigation of particulate dispersion from kerman cement plant. Iranian J Chem Eng 2006;3:65-74.

Sidhartha P. Modeling and monitoring of suspended particulate matter from Badarpur thermal power station, Dehli. Environ Modeling Software 2004;19:383-90. doi: 10.1016/S1364-8152(03)00137-3

Al Smadi M, Al-Zboon K, Shatnawi K. Assessment of air pollutants emissions from a cement plant: a case study in Jordan. Jordan Civil Eng 2009;3:265-82.

Engelbrecht J, Joubert J, Harmse J, Hongoro C. Optimising a fall out dust monitoring sampling programme at a cement manufacturing plant in South Africa. African J Enviro Sci Tech 2013;7:128-39.

Noor H, Yap C, Zolkepli O, Faridah M. Effect of exposure to dust on lung function of Cement factory workers. Med J Malaysia 2000;55:51-7.

Bertoldi M, Borgini A, Tittarelli A, Fattore E, Cau A, Fanelli R, et al. Health effects for the population living near a cement plant: An epidemiological assessment. Environ Intl 2012;41:1-7. doi: 10.1016/j.envint.2011.12.005

Yubero E, Carratalá A, Crespo J, Nicolás J, Santacatalina M, Nava S, et al. PM10 source apportionment in the surroundings of the San Vicente del Raspeig cement plant complex in southeastern Spain. Environ Sci Pollut Res 2011;18:64-74. doi 10.1007/s11356-010-0352-9

Schuhmacher M, Domingo JL, Garreta J. Pollutants emitted by a cement plant: health risks for the population living in the neighborhood. Environ Res 2004;95:198-206. doi: 10.1016/j.envres.2003.08.011

Noorpoor A, Shahabi NK. Dispersion modeling of air pollutants from the ilam cement factory stack. J Civil Environ Eng 2014;44:107-16.

Akbari A, Borhandiani S. An evaluation of pollutant gases outlet cement factory behbahan and compared with the standard. 1th National Conference on Planning and Environmental Hamadan Islamic Azad University 2011.p.1-8.[Persian].

Khaniabadi YO, Polosa R, Chuturkova RZ, Daryanoosh M, Goudarzi G, Borgini A, et al. Human health risk assessment due to ambient PM10 and SO2 by an air quality modeling technique. Process Saf Environ Prot 2017;111:346-54.

Goudarzi G, Daryanoosh S, Godini H, Hopke P, Sicard P, De Marco A, et al. Health risk assessment of exposure to the Middle-Eastern Dust storms in the Iranian megacity of Kermanshah. Public Health 2017;148:109-16. doi: 10.1016/j.puhe.2017.03.009

Zhou M, Liu Y, Wang L, Kuang X, Xu X, Kan H. Particulate air pollution and mortality in a cohort of Chinese men. Environ Pollut 2014;186:1-6. doi: 10.1016/j.envpol.2013.11.010

Khaniabadi YO, Daryanoosh SM, Amrane A, Polosa R, Hopke PK, Goudarzi G, et al. Impact of middle eastern dust storms on human health. Atm Pollut Res 2017;8:606-13. doi: 10.1016/j.apr.2016.11.005

Baroutian S, Mohebbi A, Soltani Goharrizi A. Measuring and modeling particulate dispersion: A case study of Kerman Cement Plant. J Hazard Mater 2006;136:468-74. doi: /10.1016/j.jhazmat.2006.01.050

Carrasco F, Bredin N, Heitz M. Gaseous contaminant emissions as affected by burning scrap tires in cement manufacturing. J Environ Qual 2002;31:1484-90.

Taiwo AM, Harrison RM, Shi Z. A review of receptor modelling of industrially emitted particulate matter. Atmos Environ 2014;97:109-20. doi: 10.1016/j.atmosenv.2014.07.051

Alizadehdakhel A, Ghavidel A, Panahandeh M. CFD modeling of particulate matter dispersion from kerman cement plant. Iran J Health & Environ 2010;3:67-74.

Abdul-Wahab S. Impact of fugitive dust emissions from cement plants on nearby communities. Ecological Modeling 2006;195:338-48. doi: 10.1016/j.ecolmodel.2005.11.044

Otaru A, Odigure J, Okafor J, Abdulkareem A. Model prediction of particulate dispersion from a Cement Mill Stack: Case study of a cement plant in Nigeria. J Environ Sci, Toxic Food Tech 2013;3:97-110. doi: 10.9790/2402-03297110

Ujoh F, Ifatimehin OO, Kwabe ID. Estimating Plume Emission Rate and Dispersion Pattern from a Cement Plant at Yandev, Central Nigeria. Resources Environ 2014;4:115-38.

Abril GA, Wannaz ED, Mateos AC, Pignata ML. Biomonitoring of airborne particulate matter emitted from a cement plant and comparison with dispersion modelling results. Atmos Environ 2014;82:154-63. doi: 10.1016/j.atmosenv.2013.10.020

Mohebbi A, Baroutian S. Numerical modeling of particulate matter dispersion from kerman cement plant, Iran. Environ Monit Assess 2007;130:73-82. doi: 10.1007/s10661-006-9447-7

Published

2018-03-17

Issue

Section

Original Article(s)

How to Cite

Assessment of Particulate Matter Dispersion Using Gaussian Plume Model: A Case Study of Doroud Cement Factory. (2018). Knowledge and Health in Basic Medical Sciences, 12(4), Page:16-25. https://doi.org/10.22100/jkh.v12i4.1748

Most read articles by the same author(s)

<< < 9 10 11 12 13 14 15 16 17 18 > >>